Re: Opinions on Harbor Freight 9x20 Lathe
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: bronco_buster</div><div class="ubbcode-body">So what is a good recommendation for a beginner, both size and brand? I am interested in a mini-lathe setup. But if I can get good results with something else I'm all ears. My understanding is that most mini lathes are manufactured by China, so I assume that if HF is junk, then brands like Enco, Cummins, Griizzly etc are too, since they all come from primarily one or two companies in China, with minor modifications of color and accessories?
I'm looking to thread muzzles, convert bolt handles, turn barrels and make small hard to find parts. Maybe too optimistic for a beginner? </div></div>
Grizzly tends to be the premium of the chicom products, I think QC is tighter with them and you cannot argue with the support, Grizzly has parts etc. HF tends to be bottom of the barrel. All that being said, a good size, minimum, gunsmith lathe is a 13x40. Keep your eyes open in the used market but remember, a new chicom lathe is still often better than a worn out U.S. made lathe. On that same note, if you buy a used lathe, you might find yourself hunting things like a follower rest, steady rest and other accessories.
A few models off the top of my head, a long bed Harrison M300, a Clausing 13x40, Nardini, larger Southbends, LeBlond. Avoid the older units with the electronic speed controls & what not unless you're good with electrical. Some of that can be replaced with a new VFD & motor but you have to keep that cost in mind.You also have to keep in mind the source of repair parts if they are necessary. Any used lathe should be inspected & checked in person. Lots of folks out there that pressure wash them, slap a coat of paint on them and try to get a premium buck just because they look pretty.