- Sep 11, 2018
- 300
- 72
- 48
Opinions on OCW test....
- Thread starter KOPFJÄGER13
- Start date
46.3. My reasoning being horizontal dispersion is usually shooter or wind, but the vertical looks good. At what distance was the shot?
- Sep 11, 2018
- 300
- 72
- 48
That rules out wind. I'd play with the charges between 46.2 and 46.5 and seating depth a lttle to find a better group, but fundamentals may be at play here too.
- Sep 11, 2018
- 300
- 72
- 48
What I found interesting is the shape of the corresponding groups are almost identicle.....45.3 was a good consistent load (a load I developed in the past) and now that I've went up in charge weight to get a little more velocity I found another very similar group @ 46.1.... groups seem to match up .8gr apart which tells me that's a good node for this gun, not too worried about group size, these were shot round Robin style & barrel temps varied between individual shots in each group...
If 45.3 is a node, you should find the higher node around 46.6 gr. It helps if you give powder, bullet weight and type, primer and brass.
- Sep 11, 2018
- 300
- 72
- 48
I’d be working in the 46.1-46.3 area to verify consistency and seating depth. I think that seating depth testing will flesh out your decision.
im with you id try something else i dont care for any of those groups they are all doing something different.
With Lapua brass I think you should be looking around 46.3 +/-. With Varget I doubt hot days will be an issue. You can try 46.3 and adjust seating depth. That may tighten up the group.
With OCW you look for concictancy in point of impact and you are consistent on 46.1 to 46.5.
With OCW you look for concictancy in point of impact and you are consistent on 46.1 to 46.5.
- Sep 11, 2018
- 300
- 72
- 48
I tend to agree. However, I have some reference to loads with 155's that use Winchester brass at 46.6 grains as a known OCW. Since you are using Lapua brass you can reduce the load about .3 grains and that should put you in the ballpark.
Because of the scatter you might want to check all you mounting screws, etc to make sure everything is tight.
Because of the scatter you might want to check all you mounting screws, etc to make sure everything is tight.
