I mounted a new scope today onto new badger steel rings. I didn't realize until too late that the torque spec was 15 in/lbs and not 20. I'm wondering if I potentially caused damage by torquing it this much. I assume there is no point relieving it to 15 since I've already torqued them to 20.
Scope is a Sightron SIII 6-24. I've torqued these to 25 in/lbs before using TPS rings with no issues, but TPS rings are of different design.
Scope is a Sightron SIII 6-24. I've torqued these to 25 in/lbs before using TPS rings with no issues, but TPS rings are of different design.