Hello, I am new to the forum, although I’ve enjoyed lurking for some time.
I’m looking for opinions on what caused 2 out of 20 primers to “blow out” today.
My load data:
Case: Hornady, once fired.
Primer: WLR
Powder: Varget, 37.5gn
Projectile: Hornady ELD-M 120gn
Trim length: 1.915”
C.O.L: 2.710”
Cases were full length resized, primer pockets cleaned with a brush, trimmed, chamfered and wet tumbled prior to loading. Any insight greatly appreciated.
I’m looking for opinions on what caused 2 out of 20 primers to “blow out” today.
My load data:
Case: Hornady, once fired.
Primer: WLR
Powder: Varget, 37.5gn
Projectile: Hornady ELD-M 120gn
Trim length: 1.915”
C.O.L: 2.710”
Cases were full length resized, primer pockets cleaned with a brush, trimmed, chamfered and wet tumbled prior to loading. Any insight greatly appreciated.