Hey folks, quick question, hopefully it can get an answer before I go shooting tomorrow morning.
Anyhow, I'm shooting cast lead, gas checked, lubed bullets at about 1050 fps through my .308 Savage 110 build. Nice and quiet, about one minute groups at 100 yards, good enough for what I'm doing.
Naturally, my subsonic loads run a little dirtier than my full power loads. My question is, should I scrub my bore out before switching back to my full power loads, and then foul my barrel after cleaning? My biggest concern is with accuracy; for some reason, I don't think my groups will be as tight with my full power match stuff right after shooting my subs through my gun.
Hopefully somebody can put my mind to rest here. Thanks for any info!
Anyhow, I'm shooting cast lead, gas checked, lubed bullets at about 1050 fps through my .308 Savage 110 build. Nice and quiet, about one minute groups at 100 yards, good enough for what I'm doing.
Naturally, my subsonic loads run a little dirtier than my full power loads. My question is, should I scrub my bore out before switching back to my full power loads, and then foul my barrel after cleaning? My biggest concern is with accuracy; for some reason, I don't think my groups will be as tight with my full power match stuff right after shooting my subs through my gun.
Hopefully somebody can put my mind to rest here. Thanks for any info!
