I’m finally re-joining Sniper Hide after a long hiatus.
I have been out of reloading my .308 for about 3 years because job responsibilities, retirement, selling my old house, moving into a new house, family matters and many other distractions.
Prior to all this, I was reloading my .308 with 41.7gr IMR 4064 with 175gr Sierra Match King BT in to LC NATO brass. Fortunately, I had put this load information in my .308 RCBS Die box pasted to the top-inside of the lid.
Since I was a newbie to reloading .308, I had sequence listing of steps on how to reload these cartridges on a 3X5 card somewhere in my reloading equipment. After a long and arduous search, is now missing, I also discovered my Lyman 48th edition Reloading Handbook is also missing.
So I laid all my .308 reloading equipment on my bench and logically thought out all the steps.
Here is what I came up with:
Case inspection Case & neck cleaning. Case lubing. Resizing, primer removal. Case length measurement, trimming &de-burr. Primer seating. Weighing powder & charging Bullet seating & measure COL.
Should I rearrange any of these in the sequence? Add any or delete any? I think I got them in the proper order.
RadioDude
I have been out of reloading my .308 for about 3 years because job responsibilities, retirement, selling my old house, moving into a new house, family matters and many other distractions.
Prior to all this, I was reloading my .308 with 41.7gr IMR 4064 with 175gr Sierra Match King BT in to LC NATO brass. Fortunately, I had put this load information in my .308 RCBS Die box pasted to the top-inside of the lid.
Since I was a newbie to reloading .308, I had sequence listing of steps on how to reload these cartridges on a 3X5 card somewhere in my reloading equipment. After a long and arduous search, is now missing, I also discovered my Lyman 48th edition Reloading Handbook is also missing.
So I laid all my .308 reloading equipment on my bench and logically thought out all the steps.
Here is what I came up with:
Case inspection Case & neck cleaning. Case lubing. Resizing, primer removal. Case length measurement, trimming &de-burr. Primer seating. Weighing powder & charging Bullet seating & measure COL.
Should I rearrange any of these in the sequence? Add any or delete any? I think I got them in the proper order.
RadioDude