Good Evening Hide,
I ran into a problem as I was doing some dry runs (no primer, no powder) and noticed a problem. I am reloading 40 Cal 180 grain, RNFP Blue Bullets. As shown in picture one, there is a half moon that forms on the top of the bullet. FWIW, it is happening at the Dillon Seating die.
"Seating plug 1" is the end of the seating plug I am using to seat the bullet. Is this the right end, or should I be using the end as shown in "Seating Plug 2?"
I ran into a problem as I was doing some dry runs (no primer, no powder) and noticed a problem. I am reloading 40 Cal 180 grain, RNFP Blue Bullets. As shown in picture one, there is a half moon that forms on the top of the bullet. FWIW, it is happening at the Dillon Seating die.
"Seating plug 1" is the end of the seating plug I am using to seat the bullet. Is this the right end, or should I be using the end as shown in "Seating Plug 2?"