Hello,
I bought a new Mark III Ruger 22/45 last week and installed the Volquartsen Mark II accurizing kit along with the Volquartsen Mark II hammer bushing.
In addition to this I did the slingshot gravity mod by removing the ball detent from the bolt release.
Everything was fine for awhile but today at the range it seems like the trigger wouldn't reset for the last round, when I got to the last round it would chamber it but then not fire with the empty mag, if I dropped the mag or pulled the bolt back slightly and let go I would then be able to pull the trigger to fire it.
Any ideas? I think it has something to do with the magazine follower pushing up on the bolt release when the last round leaves the magazine and goes into the chamber. Also if i wiggle the bolt release then I would be able to fire the trigger.
This also didn't happen 100% of the time.
I bought a new Mark III Ruger 22/45 last week and installed the Volquartsen Mark II accurizing kit along with the Volquartsen Mark II hammer bushing.
In addition to this I did the slingshot gravity mod by removing the ball detent from the bolt release.
Everything was fine for awhile but today at the range it seems like the trigger wouldn't reset for the last round, when I got to the last round it would chamber it but then not fire with the empty mag, if I dropped the mag or pulled the bolt back slightly and let go I would then be able to pull the trigger to fire it.
Any ideas? I think it has something to do with the magazine follower pushing up on the bolt release when the last round leaves the magazine and goes into the chamber. Also if i wiggle the bolt release then I would be able to fire the trigger.
This also didn't happen 100% of the time.