i recently was at the range with some reloads, the primers on the case had back out a small amount, did not realize until i got home, then realized i used my full lenght sizer for another rifle and i had pushed the shoulder back to far. they are only twice fired cases and did not want to scrap them if i could get a couple of neck sizing only firings out of them, what do you guys think, scrap or load them up a couple more times? they were fired in a rem 700 in .223 very mild loads and they were winchester cases. thanks guys
i have never made this mistake before and hope not to again, but i really dont want to waste the cases, im sure there life has been shortened and know that, but i dont have many cases and dont want a head seperation either
i have never made this mistake before and hope not to again, but i really dont want to waste the cases, im sure there life has been shortened and know that, but i dont have many cases and dont want a head seperation either