For those of you that put a Sako Quad in a Manners stock, did you have to mill out the side area for the bolt release? When I tighten down theaction screws, it presses on the bolt release, causing the bolt to come sliding out every time I cycle the bolt. Will bedding the action help this out some, as it should rise rise the action up some?
*After posting thsi I checked out the inletting of the stock a little more and saw that the pin thats used to hold the pin into the bolt release was touching the stock. I ground down the pin, but it didnt make much of a difference. I think the inletting may be a bit deep. Hopefully bedding it will rise the action up enough to clear the bolt release.
*After posting thsi I checked out the inletting of the stock a little more and saw that the pin thats used to hold the pin into the bolt release was touching the stock. I ground down the pin, but it didnt make much of a difference. I think the inletting may be a bit deep. Hopefully bedding it will rise the action up enough to clear the bolt release.