Suppressors Specwar Mounting

[scoobieman]

I have a .300 Blackout Aero Precision build kit with a 15" Enhanced handguard and I want the end of the Specwar 762 silencer to protrude out past the end of the handguard by no more than an inch... less if possible. The Specwar specs at 9"... and my initial plans are to use a 7.5" barrel, that has about 1/2" (maybe 5/8" to be more precise) of thread, so if the Specwar is 9"... it appears the unit when mounted would extend past the handguard right about an inch. With the barrel at 7.5" - 5/8" = 6-7/8" + the Specwar at 9" = 15-7/8". However, I am not sure about the mounting of the Specwar. Can someone owning the Specwar advise if the included ASR flash hider causes any additional length after the Specwar is mounted... and if so verify how much? I know I can go down to a 6.5" barrel if needed... if the mounting adds a half inch or so, that might be the route for me to take, but I'd like to keep it with the 7.5" barrel if possible, but don't want 2 inches sticking out past the handguard. This is strictly for fun... not hunting with it. Just looking to get the quietest .300 Blackout setup using subsonic ammo with a binary trigger, and the Specwar seems to fit the idea... and it is discounted heavily right now as well. Thanks in advance for any info on the mounting.

 

[Badfinger]

How are you going to tighten the locking ring on the Specwar under the handguard?

 

[NAS78]

OP has already been told the same thing on ARFCOM. Can't do it unless you take off the handguard every time you need to install and remove the can. I guess he thinks by asking a different group of people he might get a different answer.

 

[scoobieman]

@NAS78 ... I had not received the answer for the help requested yet... thus the reason for asking in another forum. Neither forum has told me anything I did not already know... and if you read my response there, you would know this. A little common sense will go a long way... rather than being ignorant and disrespectful.

@Badfinger ... I am going to mount the Specwar then install the handguard. It will be a permanent setup, more or less... no reason to be removing the Specwar. This is not an issue... the issue is trying to verify the overall length so that I can order the correct barrel.

 

[scoobieman]

I have received an answer on the other forum... no further assistance is needed.