Spuhr picatinny rail height measurements

[ocabj]

I was on the Spuhr site - https://spuhrwebshop.com/en/accessories/rails/ - and it wasn't clear on where the height measurements are taken for the rails (no schematics for any of the rails)

If it says height of 10mm, 14mm, etc., is that measurement taken from the bottom of the rail to the very top of the rail, or is that from the bottom of the rail to the bottom of the picatinny rail groove?

Thanks.

 

[Tnc]

Check out mile high shooting website. Each spuhr mount is shown with corresponding heights and where they are measured from.

 

[USMC mustang]

The height of a Spuhr mount is measured from the top of the pic rail to the center of the scope.

https://spuhrwebshop.com/en/choose-your-mount.html

 

[ocabj]

The height of a Spuhr mount is measured from the top of the pic rail to the center of the scope.

https://spuhrwebshop.com/en/choose-your-mount.html

Not asking about a Spuhr scope mount. Asking about Spuhr pic rails that attach to the Spuhr mount. Note the URL to the rails in my original post.

 

[ocabj]

Check out mile high shooting website. Each spuhr mount is shown with corresponding heights and where they are measured from.

MHS doesn't have schematics either.

Example - https://www.milehighshooting.com/spuhr-a-0037-picatinny-rail/

Only has the height value, but not where it's measured. Still unclear of those measurements are from bottom to low portion of the groove or from bottom to top of groove.

 

[Tnc]

Man I can’t find it now. I swear I just looked yesterday and one of the spuhr mounts had a picture that showed the measurement from the centerline of the cross bolt to the center of the scope body

 

[ocabj]

Man I can’t find it now. I swear I just looked yesterday and one of the spuhr mounts had a picture that showed the measurement from the centerline of the cross bolt to the center of the scope body

Not sure how the scope body has anything to do with the rail height measurement I'm asking about.

 

[Tnc]

Misread your first post. Thought you were looking for mount heights. Didn’t know spuhr made rails. Good luck with your search

 

[kydron]

I was on the Spuhr site - https://spuhrwebshop.com/en/accessories/rails/ - and it wasn't clear on where the height measurements are taken for the rails (no schematics for any of the rails)

If it says height of 10mm, 14mm, etc., is that measurement taken from the bottom of the rail to the very top of the rail, or is that from the bottom of the rail to the bottom of the picatinny rail groove?

Thanks.

If you compare one of the lowest height accessory rails to the 1913 specification you'll see that there is a minimum .367" clearance required from the bottom to the top of the rail. Given this looks roughly the same as the product I linked, it would make sense to me that the height numbers are all to the top of the rail in the manufacturer's height specification.

 

[RayDBonz]

Email Spuhr or Mile High and ask.

 

[Maveriten]

Call Mile High. In my experience, those guys bend over backwards to be helpful and the people I’ve spoken with there know the product well. Better to remove all guess work.

 

[ocabj]

I ended up getting one sight unseen. The measurement spec advertised by Spuhr is from the bottom of the rail to the very top (top of groove).