Stiller TAC338 & Seekins Lapua DBM

[cutarm]

I asked over in Gunsmithing and I'll ask here too.

Anyone here running a Stiller TAC338 repeater action with Seekins Lapua 3.900" DBM?

Does the combination work well? Is there a bit of milling that has to be done to the bottom inlet of the receiver?

 

[D_TROS]

Re: Stiller TAC338 & Seekins Lapua DBM

I have that set up and it functions very well.
No smithing or altering.

I prefer seekins BM cause the release is on side and not sticking out the bottom

Regards
DT

 

[Danhalen7.62]

Re: Stiller TAC338 & Seekins Lapua DBM

What barrel and stock/chassis?

 

[D_TROS]

Re: Stiller TAC338 & Seekins Lapua DBM

Shilen select and a McMillian A3 chambered in 338LM. Just reg ol krylon on barrel.

Pushing 300 SMK 2720 fps with a 22" barrel with 92 of H1000 and no pressure signs.

The TAC338 a very solid platform

Good luck
DT