Stupid question incoming! (adhesive?)

[SuperSneakySniper]

Hey guys,

I'll make this quick. For things like the SAP 2 round holder, or the Sidewinder dope card holder, it requires the use of an adhesive piece that attaches to your rifle...

Will that come off if I decide to sell the rifle/stock in the future, and if so, will it screw up a cerakote finish if it was on there for a long time?

Sorry for the dumb question.

 

[diverdon]

If it is on the Cerecote, after you pull it off if there is some adhesive stuck to the rifle just use a little rubbing alcohol to take it off and you should be fine. The reason we pay the big bucks for Cerecote is because it is the good stuff!

http://www.cerakotehightemp.com/news/article/chemical-resistance-of-cerakote-ceramic-coatings/

The ability of Cerakote™ High Temperature coatings to resist chemical breakdown was tested by dipping coated panels into a series of solvents and allowed to sit for 24 hours. Afterward, the samples were removed, analyzed and assigned a rank depending on the resistance to each specific chemical. The results of this test are shown in the accompanying chart. The performance of Cerakote™ C-186, C-7300, and V-171 was classified as excellent for the solvent tests. This indicates that the coating was not affected following a 24-hour immersion in the solvents. W-207 Chromex performed excellent in 9 of the solvents and performed fair to good in the remaining solvents.

 

[...]

if you remove it carefully, it shouldnt harm the finish......a little acetone should remove the adhesive and shouldnt harm the cerakote.