Supertrickler Gen 2 Tuning

[emrekt888]

Howdy,

I've got a supertrickler gen 2 and I wonder if anyone has any tips for tuning it for optimal loading times?

I have experimented with adjusting the bulk, fine, and pulse rates and letting the AI sort of trim up or down to get that .02+- threshold, and it can now get damn close in 2-3 seconds...

But it does this annoying as hell thing where for some reason no matter the base vibrator rate, on/off rates, ramping rates, etc... the powder seems to either have the last few kernels further back in the tube so it takes 10-15 extra seconds for it to migrate it up and drop it.

OR, the powder will somehow build a little log cabin and will take 5-10 seconds to drop it, at which point it will be an overcharge.

Does anyone have an experience with this? not a lot of information out there about using these really high end lab scale and trickle setups.

 

[R_A_W]

Does anyone have an experience with this?

yes, every supertrickler owner ever

The "AI" sucks, I stopped using it a long time ago

Unfortunately, you're just going to have to play with stuff until it works for you. I think these are my N150 settings. They could be improved a little, but this throws in 8.5 sec @ 85%

Varget just wants to overthrow, I gave up:

 

[secondofangle2]

It is just the nature of the system with that vibrating tube, and some powders are gonna be worse than others, namely the larger extruded powders

 

[Baron23]

any tips for tuning it for optimal loading times?

I think this is @secondofangle2 real recommendation but he's being polite! haha

 

[03machstock]

Like the others said, just kind of the nature of the beast. Iv had pretty good luck with n540 but the kernels are smaller than varget this flow better. Here’s a shot of my average varget session. Iv got the bulk dialed in pretty good but the fine adjustments need work. I load on a Dillon so waiting a little longer doesn’t bother me, but the overthrows do.

 

[avidflyer]

Like the others said, just kind of the nature of the beast. Iv had pretty good luck with n540 but the kernels are smaller than varget this flow better. Here’s a shot of my average varget session. Iv got the bulk dialed in pretty good but the fine adjustments need work. I load on a Dillon so waiting a little longer doesn’t bother me, but the overthrows do.View attachment 8698747

What powder shield is that?

 

[03machstock]

What powder shield is that?

Got it of a hide member that 3d prints them, the add ons help a lot, I spill 0 kernels now, just a matter of dialing everything in.

Reloading Equipment - SuperTrickler Accessories

This kit helps eliminate the stray powder kernels during hopper loading of the SuperTrickler and clearing out the hopper without having to shake the unit and try and open the trap door with one hand while holding over a container. The funnel is a very light press fit into the top of the...

www.snipershide.com

 

[secondofangle2]

“Spiller shield” for the SuperSpiller!