Suppressor questions with PTR Vent 1

[Qcf0rd88!]

So I'm a noobie...I'm looking at the PTR Vent 1 762 suppressor. It comes as a direct thread to the barrel. I called PTR and they said I could use a muzzle break setup as long as it doesn't protrude into the suppressor more then 1.5 inches. So I'm looking for advice on which muzzle break to use. Also. I wanna switch the suppressor from my pof 556 to my pof 308. They both have different threading. How/ can I do this? Please help lol
Thanks
Ed

 

[DHDeal]

You will need a HUB mount for the suppressor and corresponding barrel mount. Typically you can get the barrel mounts in 1/2×28 and 5/8×24.

One example is the Dead Air Xeno system.

 

[TonyAngel]

Plan B is another taper mount system that is pretty popular. Although I use the YHM SRX taper mount system, if I had it to do over again, I'd likely start with a Rearden Atlas/Atlas XL mounting interface for the suppressor and Plan B muzzle devices from a manufacturer of your choosing.

It is likely that you will need a muzzle device threaded 1/2x28 for the 5.56 and one threaded 5/8x24 for the .30 cal. Once you have the adapter for the suppressor, it will thread onto both muzzle devices.

With a shorter brake (like a single port or other compact design), you'll likely be fine with the Atlas adapter. For longer brakes, you may need to go with the Atlas XL for the clearance you need.

 

[Clayman]

Rearden Atlas system is where it's at imo