Gunsmithing Two stage for mausingfield

[hunter223]

built my mausingfield on my lathe this weekend and it flat ass shoots but when I attempted to run my timney two stage 532ce , it won't let the firing pin fall. Ted said he didn't know what two stage would work and didn't have a suggestion on a trigger so I'm looking for one here. Thanks!

 

[diverdon]

Huber works perfect on mine. One reason your Timney might not work is that you might have inadvertently pinched the side plates when you installed the pins that mount the trigger to the action. If there was any more than light tapping involved you might want to pull the trigger and gently spread those side plates and reinstall it.

 

[hunter223]

Never thought of that, I'll check that. Thank ya

 

[mm509]

The Timney CE 2 Stage runs fine in my Mausingfield

 

[missed]

I think I'm going to go to the Tubbs T7 for mine. Hopefully someone will chime in that it works.

 

[diverdon]

Huber is having a 100 bucks off fight now, and John is a good guy. https://www.facebook.com/HuberConceptTriggers/ At $295 it is not a bad price for a nice robust trigger.

 

[hunter223]

The sides of the timney weren't pinched at all, any other suggestions as to what the issue might be?

 

[OinCO again]

I use Tubbs T7T on mine- couldn't be happier

 

[Eagle1899]

Make sure your chassis is not pinching the safety. The Timney 2 stage has a different lever that pivots very low on the trigger. The two I have required me to clearance the trigger guard.

Other than that, check and make sure you have enough over travel to clear the sear falling away.