Rifle Scopes USO ST-10 zero stop?

[cj1026]

So today I went out and sighted in my new ST-10. Awesome scope!

Now that it's zeroed is there a way to set the zero stop?

Or do I need to go back, run the center hex screw counter clockwise, then turn the EREK clockwise and re-zero with the center hex screw?

Thanks for the help guys.

 

[Rafael]

Re: USO ST-10 zero stop?

That's how you do it, if everything works as planned.
Use caution and do not force it if you cannot achieve zero near the bottom of the outer knobs travel.

I like to back off the center screw, then run the knob down to stop, then come up 6 clicks or so......and make that my zero-point. This way you do not have to be as precise with the center screw, and it leaves you room to adjust for other variations.

 

[cj1026]

Re: USO ST-10 zero stop?

Rafael

I'm a little confused. So now that my scope is zeroed, I follow the steps in my original post?

Thanks

 

[Rafael]

Re: USO ST-10 zero stop?

I was agreeing with the last part of your post.....
Run the center screw out(counterclockwise), run the outer knob down to stop(or near it; as I sugggested), adjust the center screw for zero. Last step, of course, zero the outer knob by loosening the two screws on top and turning it to zero.

 

[cj1026]

Re: USO ST-10 zero stop?

Ok so I have to re zero my scope on the range?

 

[Rafael]

Re: USO ST-10 zero stop?

Yup, that would be wise.

 

[cj1026]

Re: USO ST-10 zero stop?

Thanks Rafael. I appreciate the help!