Hey guys, Just wondering if anyone who uses a wilson case trimmer with their vld 30 deg chamfer tool (the one that uses the crank handle just like the trimmer) has had a problem with not being able to get an even chamfer all the way around the case mouth??
I have to rotate my case 180 and then a 1/4 turn then 180 deg again to get an even chamfer all around my case mouth on all my cases all brass. This is after the sizing, process, neck turning or on fired brass without the prep.
I called wilson and they said their bearings although square may or may not be concentric to their case holders.
has anyone else had a problem with this? Would the K&M vld tool be easier to use??
Thanks in advance!
I have to rotate my case 180 and then a 1/4 turn then 180 deg again to get an even chamfer all around my case mouth on all my cases all brass. This is after the sizing, process, neck turning or on fired brass without the prep.
I called wilson and they said their bearings although square may or may not be concentric to their case holders.
has anyone else had a problem with this? Would the K&M vld tool be easier to use??
Thanks in advance!