I bought a MagnetoSpeed V2 and hope to use it this week. I have been looking it over and getting it set up. Hoping some of you that have been using it would give your opinion of the spacing from the bore.
I used a couple different spacers and this looked the best to me but not sure if it is too close. I have it set up using my suppressor. You can see the piece of rod that I have placed in the bore (very carefully) to use as a gauge.
I did look through the barrel from the chamber end and I can not see the Bayo sensor so I "think" I'm ok.
Please let me know what you think.
Thanks.
I used a couple different spacers and this looked the best to me but not sure if it is too close. I have it set up using my suppressor. You can see the piece of rod that I have placed in the bore (very carefully) to use as a gauge.
I did look through the barrel from the chamber end and I can not see the Bayo sensor so I "think" I'm ok.
Please let me know what you think.
Thanks.
![MagnetoSpeed002_edited-1.jpg](http://i251.photobucket.com/albums/gg290/jmadonia/MagnetoSpeed002_edited-1.jpg)
![MagnetoSpeed006_edited-1.jpg](http://i251.photobucket.com/albums/gg290/jmadonia/MagnetoSpeed006_edited-1.jpg)