curious as to how I can rezero the turret scales on the g3 razor, On my g2 I just loosen the 3 screws lift up and put scale to what ever I want. have tried to lift the scale on the g3 but will not work. Has anyone been able to reset their turret scales[for lack of proper terms. stan
gen 3 razor turret adjustment scales
- Thread starter Ruslow
- Start date
The Gen 3 turret system is different than the Gen 2 turret system. It is very easy to zero the turrets. To reset the turret to the zero stop, you loosen the set screw on that turret.
Review the manual, then watch this video:
Review the manual, then watch this video:
What are you talking about? You leave the turrets on zero and locked and then loosen the one screw and then zero the rifle with the top dial. That simple. Then tighten one screw when zeroed and done. No need to do anything else.
How did you do it on the G2 and why does it matter to begin with? Your optic is zeroed by using the internal adjustments under the cap on the G2 and you leave the external at zero. It’s the same concept on the G3 you just don’t have a quarter sized cap to cover them.
I agree with the others, no way or reason to zero the inner adjustment on the G3.
I marked the inner hashmarks with a fine tip sharpie to color code the zero for when I change barrels/calibers on my rifle. You could always do this for reference.
Red is 308 and green is 6mm CM.
I marked the inner hashmarks with a fine tip sharpie to color code the zero for when I change barrels/calibers on my rifle. You could always do this for reference.
Red is 308 and green is 6mm CM.
I hate the g3 razor turrets. Zeroing them is a pain in the ass. One of the reasons I sold them off. One of the dumbest designs out there.
It's retarded trying to figure out which direct to turn a micro disk when every other turret on market you loosen and slip to zero. It's a dumb design and the turrets are garbage compared to the gen 2 razor.
The inner section could be lifted out on the Gen 2 and re-indexed. I never bothered though.
Yeah if only there were markings on the turret for which way you should go. It'd be pretty cool if it matched the direction you go for normal operation too... oh wait
Working scope turrets is really difficult aint it?
Yeah that is a disk on a spline. With the screws loose it can be removed. It can also be replaced if it gets too much screw damage.
To be fair, years ago I initially didn’t realize you had to tighten the screws on the turret for the G2 (they were already loose when I purchased it and obviously I didn’t read the manual)
I got the thing zeroed on a PRS22, showed up to my first stage of my first match, hit like 2/10 targets, chalked it up to me being shitty, next stage I miss every target and I think, “well I’m not that bad” I take off the cap and I changed my zero like 20 mils lmao.
So, moral of the story, read the manual and even if it exists people are retarded.
ETA: it changed because I was dialing up, so it would adjust the internal dial up but not back down. So I just kept on dialing higher and higher up lmao.
