• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by AKA-Spook

  1. AKA-Spook

    Gunsmithing Muzzle brake on small dia barrel

    This 1/2 x 28 will be fine.
  2. AKA-Spook

    Gunsmithing When the bore absolutely, positively has to be copper free...

    few patches of montana extreme every 500 rounds whether it needs it or not.
  3. AKA-Spook

    need advice on rifle

    yep +1
  4. AKA-Spook

    My MDT LSS 308 shorty build

    13 ... its a smidge short, but I'm usually wearing several layers when calling so it works out OK?
  5. AKA-Spook

    Any 338 Norma Mag fans?

    yes, nicely . Ultramag length mag opening.
  6. AKA-Spook

    Any 338 Norma Mag fans?

    OhNoMrBill just did a 40 degree Imp version
  7. AKA-Spook

    My MDT LSS 308 shorty build

    Thanks Phen
  8. AKA-Spook

    My MDT LSS 308 shorty build

    Same stock in Model 7 with side folder. AICS 223 mag- 17 mach 4 ...for coyotes. 27 inches with 16" barrel.
  9. AKA-Spook

    458 SOCOM AR Build

    ...its been said "If it bleeds you can kill it with a 458 Socom". That should be amended to include "If you're close enough to it..." Feeds from GI's like corn through a goose and if you set everything up correctly it will go bang every time you pull the trigger. I've built several for guys...
  10. AKA-Spook

    1:8 twist too fast for 22-250?

    I have an 8T on a 22-243 Middlestead that has 80 amax going 3550 fps... works very well for the heavier projectiles. Shot 55 dogtowns to fireform without issue.
  11. AKA-Spook

    Gunsmithing .308 tensioned barrel? Possible or a waste of my time?

    p.m.'ed ya Ben
  12. AKA-Spook

    Gunsmithing AR15 barrel cant/ issues with barrel extension questions

    ....is this with regard to the axial alignment of the barrel / receiver union or the front sight leaning one direction or the other?
  13. AKA-Spook

    Gunsmithing AR15 barrel cant/ issues with barrel extension questions

    I just had something very similar with a 6mm Grendle barrel I turned, canted hard left. Pulled that barrel and put a JN barrel in its place, same deal. I put the upper receiver in the mill using the scope rail as a clamping point, just barely faced the receiver (.010) and reassembled .... It...
  14. AKA-Spook

    300 blackout

    This road sign was shot, one time, from 1000 yds with the 300blk. Who would have imagined a round with so little capacity could cause devastation like this?
  15. AKA-Spook

    Gunsmithing anyone crown with a carbide incert?

    I do something very similar. Carbide is your friend.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts