Recent content by FNuser

Re: Favorite Brew Thead. Just got back from a trip to oregon and sampled alot of micros got to say I really like the i.p.a.'s the best.

Re: Varget vs. IMR 4895 vs. RE-15 My best .308 load is Rl15 and 168 smk's in lapua over a fed gm

Re: Neck turning? I've found that its not neccesary to get 100% of the neck turned to make a huge difference I started just hitting the high spots so that 75% or so gets turned down. try it you might like it.

Re: Favorite Base? Long, Wthby Vanguard, Got my tracking # last night.

Re: 308 Vargert or Rl-15 lapua brass 168 smk's 43.5 g rl15 fed gmm lr's no pressure sign

Becky just called so my uso is on the way, putting it on a howa, same as remington profile what everybody's fav and why.

Re: 7mm 175 sierra matchkings I load a buddy's 7rm with 175's and 22 mine is a 280 ai w 1-8 22 works there too.

Re: Anyone built a .284 repeater for comps? I've had no trouble getting .280 ai nosler brass as for expense factor in the cost of components it takes to fireform brass in your rifle and I don't think they are that far out of line. If you've been under a rock the last month or so you probably...

Re: 8mm RM/200SMK COAL questioned I've had more than one caliber shoot Sierras w as much as .2" jump that however is the only brand I've observed that way Bergers usually require a Jam fit and noslers Balistic tip the expected .01" jump.

Re: Shot at a deer today at 900 yards, wounded it. Better luck next time.

Re: Use of available resources... You can do the same thing in a Honda CRV but you got to stay flexible.

Re: strange vibration when fireing my .308 This happened about 20 years ago to me I was shooting an old scope that was too long for the distance between mounts, It was a Redfield 3200 and the scope was "twanging" everytime I pulled the trigger it was a 6-284 so there wasn't alot of recoil but...

Re: Loads for 280AI I bet ya .257's gonna say rl22 for the 180's, seriously though whats your barrel length for that velocity quote? I've got a Hart 1-8 that exceeds the normal length.

Re: Brass OAL Question maybe a cerro-safe chamber cast or a crayon would tell you the actual length of your chamber's neck. After you find this you would then have a real world max for that rifle. miss the max by .01 or so and you should be good.

Re: Brass OAL Question usually leaving a >.250 dia. place for bullet, gas, etc, hurts accuracy but as far as safety goes I don't see a problem however too long is a different story so if you feel like you need some room somewhere because your stuff ain't as tight as it could be I'd say you're...