Recent content by GoferDog

You can always count on a retarted and arrogant comment from 308buttpirate…

pm sent

Thanks for the reminder 👍🏼 This thread is a sassy as a high school girls locker room 😂

Not a single response to the thread unfortunately.

Just chasing experience from anyone who has an AI and a Badger, could you tell me if the AI Action will drop into a Badger inlet? Reason for this is that McMillan don’t have an AI inlet but do inlet for Badger. Action screws will be irrelevant as it will be glued in 👍🏼

I will do that Milf

Just chasing experience from anyone who has an AI and a Badger, could you tell me if the AI Action will drop into a Badger inlet? Reason for this is that McMillan don’t have an AI inlet but do inlet for Badger. Action screws will be irrelevant as it will be glued in 👍🏼

Thanks

Just chasing experience from anyone who has an AI and a Badger, could you tell me if the AI will drop into a Badger inlet? Reason for this is that McMillan don’t have an AI inlet but do inlet for Badger. Action screws will be irrelevant as it will be glued in 👍🏼

PM sent Cheers

I couldn’t care less what they are based on either way, I just don’t want people thinking the two cases are interchangeable…

Yes but they are different, look at a reamer print. I just ran a 300 WSM small base die over some SAUM brass - it didn’t even touch the base of the case…

WSM and SAUM are slightly dimensionally different at the base of the cartridge. I have both.

Lol lol lol. I think the Creedmoor is a gay as aids but you won’t see a significant jump in velocity by rechambering, the case capacity is very similar. Most 6.5x47 hand loads are significantly faster than Creedmoor hand loads - it’s the poor quality Hornady brass that holds the cartridge back...

This is possibly the stupidest thing I will read all year