• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by jaycoux

  1. J

    So who has done actual groups at 200 with a tavor?

    I’ve done a fair amount of load development in my Tavor 7 and found that it really likes Hornady 155 HPBT match projectiles. This is the same projectile that’s in the Hornady steel match 155’s. If you reload you will find that these will give you great results. I’m loading at 2.79 COAL and...
  2. J

    New member seeking help JP LRP-07

    To answer your question-no, I do not consider 1.5 yrs to be a long time, but I have had a very high end scope croak from spring fatigue after sitting up for about that long. It was on a sloped base, so it was cranked down more than the average scope and it failed, not 8” or anything but it did...
  3. J

    New member seeking help JP LRP-07

    Whether or not you are familiar with shooting a large frame gasser, if you are getting 8” groups it might be wise to pull the scope and put it on a known entity to verify. Might have someone go through the rifle as well to verify. This all depends on how long ago the previous owner used it...
  4. J

    Firearms Desert Tech SRS Rifles - Fall Sale

    pm sent
  5. J

    Tavor 7; Ammunition problems- Factory vs. Reloads

    Not that I’ve seen. One way to check on the Xtreme bullet is just to check the ogive compared to your commercial stuff.
  6. J

    Tavor 7; Ammunition problems- Factory vs. Reloads

    I'm not sure what to say about that if it fires factory stuff without issue. My Tavor 7 has never seen a factory round, just reloaded LC cases. Never had a problem. I've never used a small base die either. Don't think it’s the trim length if your numbers are accurate. My datum measurement...
  7. J

    Tavor 7 & Baffle Strikes: searching for insight, ITT you can laugh at me

    I know this is an old thread but there is a company in Texas that makes a barrel shoulder washer for a Scar17. The Scar17 shoulder and the Tavor7 shoulder are very similar and it works perfectly in the Tavor7. Anyhow, I've run that washer with my suppressor and never had a problem. Using the...
  8. J

    Firearms WTB Accuracy International AW/AWP with fixed stock

    Why not the folder? Just curious...
  9. J

    Firearms AI Arctic Warfare .308

    Interested in your AW if it's still available. Give me a shout on pm or cell five one two 63o-121four.
  10. J

    AI Comp Trigger

    For anyone running an older AW and stock skins you will need to Dremel out the back portion of the trigger hole of the skins to allow the trigger to function. Required about 1/4" to work properly.
  11. J

    Scar 17 help

    I agree with above. I had to special request the shim from surefire for my 17. And not alot of the cs at SF knew what I needed. I may still have mine, I'll snap a pic of it for your reference if you want. I would pay special attention to what it assume would be the brake you installed...
  12. J

    338 Lapua alternative?

    David Tubb is going to release a new cartridge in the next few months, a 33XC. Should be a significant improvement in performance compared to the 338LM. It can also be necked up to 375 if you want to go that route. He has discussed the case and rationale on his Facebook if you want more...
  13. J

    .338 Lapua Muzzle Brake

    Check out David tubb's 5-star muzzle brake. Really great all around brake. They will drill the bore whatever caliber you want.
  14. J

    ...Interesting Post on 224V Accuracy Issues

    Redneckbmxer24, which blank and length did you get from craddock?
  15. J

    Has anyone reviewed the new Tubb rifle?

    I think you will find the ATR is very capable in many forms. I sold my AXMC.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts