Recent content by jim10801

Response to a PM from Sean: The expanding mandrel and the 5c collet block set was purchased from Shars Tools. I think the 5c collet set came from Grizzly Tools but my memory is a little fuzzy. I'm a believer in "Buy quality tools and cry once or buy cheap and cry every time you use them"...

I have often seen/heard this incomplete quote. It usually applies to tools, firearms certainly belonging to the gruop. Buy quality and cry once, buy cheap and cry every time you use it.

Thanks for the responses. I viewed the videos by Joe Carlos. I contacted him with additional questions. He convinced me that the lapping tool sold by Brownell's and similar products sold by others was not the best way to go when truing up the receiver face. Further research on the internet...

I have a Rock River Arms NM A4 20 Inch CMP Rifle (2016) LAR-15, which is used in NRA High Power and CMP shooting. The current original barrel is showing some throat erosion. I purchased a 20” HBAR replacement barrel from Krieger that will be installed down the road. Did some research and...

Jmkjr87, Not certain if your reply was directed to me but if it is, the specifics are this. The remanufactured ammo was commercial made by a well known company. There quality control had some issues in that every once or twice in several boxes a bad round would show up. I measured the rounds...

If you can access the bolt carrier from the bottom (by removing the lower receiver) use a short wood or brass dowel, about 3/8" in diameter and about 3 or 4 inches long and place on end located against an appropriate beefier part of BCG and drive it back with a small hammer. I have had out of...

One would assume so. They are AI's factory authorized service center. But that is just my uninformed speculation.

I wrote to Mile High a couple of weeks ago. This was their response: -------------------------------------------------------------- They are on order, but we have no specific delivery time as of yet DAVE BUICK Mile High Shooting Accessories 3731 Monarch St.Erie, CO 80516

It is an old school battle rifle, but a fun gun to shoot. https://www.classicfirearms.com/m14-rifle-new-semi-auto-walnut-stock-bula-parts-jra See the forum for more info: http://m14forum.com/m14/385161-new-jra-m14s.html

I was interested in a LaRue 'Covert' case but as the AT is now it would be awkward. The stock folding to the right should shave off a good deal of width. It would almost be like a new rifle.

Waiting to see what the bottom line will be with the install and shipping. But, does it come in the current AT colors?

I have a small lens from him that fits in the hooded aperture of my M1A. Works great. He also sells complete glasses. http://bjonessights.com/

Been in the maritime industry for 40+ years and have always said if you what to double the price of a product just stamp "Marine" or "Marine Grade" on it.

Contact Adam Rehor at Mile High. [email protected] Adam Rehor Mile High Shooting Accessories Accuracy International Certified Service Center 303-255-9999

Still interested.