Recent content by les_garten

btt

Was this sold?

BTT

I am looking for a like new Condition One Badger Ordnance 34mm 1.70 in TAN

I watched that video last night from another thread. Thanks!

I'm locked into the muzzle device. It is a 360 brake and requires no timing. I'd like to mount it with just a minimal amount of torque. I cannot use any washers. It has to index on the Sig Taper. Rockset or Loctite Red, which? How about maybe 10# torque and the glue?

Lots of issues with Sig MPX muzzle devices in the past with accuracy. I can say that I shot mine with the new muzzle device today and it groups 1" at 25 yds. I just put a little torque on it, no measurement, just a "bit" to stick it. Shot twenty rounds to see how it did. I was reading...

Shot it today with the new Muzzle device and it was around 1" for 5 shots at 25 yards. So next month the range where my Wolfman is being held hostage will be renovated and I'll shoot it then and we'll see.

That's not the issue. I'm familiar with the company. I need to speak to the owner. I thought maybe someone would have an inside track.

How do I get in touch with him? Does anyone have a direct email or phone number?

Does anybody have any inside emails for the owner at Compass Lake Engineering. Having some issues... Really would like to speak to the owner. I guess that's Conrad White or Frank White?

When you cut and rethread a barrel, do you have to find someone who can recrown as well? Or is that part of the deal?

LOL, I just checked my sock drawer.. What do ya know, I got 4 pennies in there. Unfortunately that's about it on the equipment...

I would be sending just the barrel. I am using a forward Controls design 6315KM muzzle device

I need a barrel cut and threaded. It's an expensive barrel so I'd like to find a good shop that can do it. It would be great if they were in SouthEast Florida, but not mandatory. Any suggestions?