Recent content by MajorHeadTrauma

Looks sweet Sent from my iPad using Tapatalk HD

Look at APA for brakes. Sent from my iPad using Tapatalk HD

If you decide on 21st Century tools, go to there Facebook page and take advantage of their 10% discount code. Sent from my iPad using Tapatalk HD

Try it with Viper Skins. They have a thumb notch at 1:00. Perfect Sent from my iPad using Tapatalk HD

What he said Sent from my iPad using Tapatalk HD

The primers appear to be crimped. You will need to swag the primer pocket prior to reloading them. Sent from my iPad using Tapatalk HD

Hi, I appreciate your frustration. I think you are getting some good advice. If I am allowed to make a suggestion, you may consider investigating if you have an issue with a donut at the junction of the shoulder and neck. The wall thickness of Lapua brass in the body is rather thick. As you...

What he said. I ave a spare spigot somewhere Sent from my iPad using Tapatalk HD

What caliber? Bullet? Seating depth? Sent from my iPad using Tapatalk HD

You could park a tank on that beast. Sent from my iPad using Tapatalk HD

Purdee

Great thread

Your load is a bit hot. To identify the appropriate load, we need to see your target results. Have you followed an OCW method? If not, give it a read. You are best to start your loads near 41 grains. Sent from my iPad using Tapatalk HD

This is solid advice. As others said, numbers down and float the bushing. The bushing must float. Just tighten it down and back off a 1/16th or 1/8th of a turn. .004 is too large of a final step. .004 works possibly as a first step, but as you approach your final desired neck diameter, use .002...

I think you will be pleased with Whidden. They have always been very responsive to my requests. They have been more than willing to machine products to adapt to changes Sent from my iPad using Tapatalk HD