• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by va_connoisseur

  1. V

    Reloading Equipment Power, Primers, and Projectiles - N. VA

    I'll take the LRP and a couple bottle of 2520. I'm near Quantico.
  2. V

    Issues bumping back the shoulder on brass

    I took out the expander ball. I'm going to anneal them, and see if that helps
  3. V

    Issues bumping back the shoulder on brass

    Thanks. I am going to start looking at the Annealez 3.0. Seems like one of the best budget annealers. Any other suggestions?
  4. V

    Issues bumping back the shoulder on brass

    No, I do not anneal. Based on the responses, it appears I need to look into that
  5. V

    Issues bumping back the shoulder on brass

    The measurement is typically 1.214-1.216 after firing
  6. V

    Issues bumping back the shoulder on brass

    I ran into a strange situation today and wanted to get feedback from the horde on what could be causing the issue. Here's the situation. I am working on a load for my 6.5 Grendel. This is what happened. I started with 50, four time fired Hornady cases. All the cases were fired from the same AR...
  7. V

    Large variance in Federal SPP 45 acp brass weight

    I was loading some 45 acp brass and decided to weigh a few just to ensure the AP was not overthrowing powder. When I noticed several bullets were over 7 grains difference. Thinking I had double charged the rounds, I broke down 10 rounds (5 "high" and 5 "low"). The bullets and powder was all...
  8. V

    Repurposing a full length body die

    Thanks for the info. I had a spare set sitting around and wanted to use it. I'll just use it for the AR-10
  9. V

    Repurposing a full length body die

    I have a set of Hornady Match Grade dies for .308 that I know longer use. If I remove the pin/innards from the FL sizer, will be still bump the shoulders without effecting the neck? (I have a collet die for neck sizing).
  10. V

    New 308 die set

    Thanks for all the input
  11. V

    New 308 die set

    Honed our Forster dies?
  12. V

    New 308 die set

    I’m planning to upgrade my die set. I currently use the Hornady Custom Grade dies. They were my first set and I have loaded some decent rounds, getting around .75 MOA out of my .308 Ruger Precision. I am considering the Redding Competition Pro Series or a created set with a Forster Bushing Bump...
  13. V

    WTS Reloading stuff: Rockchucker/dillon 550 conv's/dillon parts

    How old is the Rockchucker? Pic?
  14. V

    Frankford Intellidropper - Quick review

    the manual says at least 15 minutes. I usually do 30-45.
  15. V

    Frankford Intellidropper - Quick review

    May as well keep it flowing here. Since my initial review I’ve run about 200 more drops. I’ve had Zero issues with drift or overcharging.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts