Search results

One issue with bc numbers is that they vary based on velocity. Ie you bc at the muzzle will be different than say 500y down range, which is different yet than 1,000 down range. The custom drag curves help with that.

anyone got anything for 26" DTA barrel, 338 LM with 300 Berger OTM's and Retumbo?

To those who own the Otto's, do you know if I can get custom molded earpieces made for them? I'm assuming an audiologist should be able to do it?

I just ordered a set with the eBay 15% off everything coupon for 300 shipped.

What do you mean below and right of what?

Should ammo temperature come into play when you do load development? You want to pick the middle charge on your node, my understanding is so that temperature fluctuations will not make you shoot high/low at different times of year, is this correct? In that case, if you are shooting on one of...

so is the lyman the way to go? I was thinking about getting one of those "anroid phone" usb ones.

Awesome, think i'll just shoot some fowlers through it, do a load development and then, after all my brass is 1x fired (i full length size, bump the shouler back .003), i'll run through it again just to confirm. 300 pieces of brass seem good to you? For my DT 308 barrel i had bought it with...

Haven't done a load development cycle in a while and when i did i was not using new gear. I have a new 338 barrel for my DT SRS, and i am going to purchase some Lapua brand brass. Generally speaking how many pieces of brass do you think i should buy? I'd like to get enough to last the life...

You can not use tsa locks when flying with a gun per federal regulations. There are reinforced eyelet holes for padlocks on the nanuk, just like what you would use with a pelican case.

so are these actually the exact same as the etymotic elite? Given the etymotic elite's are delayed, makes me wonder if there are issues with the product that etymotic are trying to work out before releasing them.

I'll say, I'm not surprised. Not as a dig against AMP, but just any new product by a smaller company tends to have delays. I see it all the time, esp now with crowd funding.

I have an era mount and it's a beast. My only complaint is that it's in moa and not mil. The snipex looks like a questionable design to me.

for hard cases Nanuk are how i roll. the latches blow pelican out of the water.

I love my sert cases. I'll stick the soft case in a hard case for flying. I'm always changing stuff up to the point that cutting foam is a waste

Interested in both the drop tube and "pan"

How are you liking the whidden dies? I'm considering getting those or the new ones out from Applied Ballistics Weapons Division.

Doesn't seem like there are a lot of choices out there. I usually use seating dies that have a sliding sleeve, doesn't look like anyone makes those for 375? I have a DT HTI fwiw. I don't have any fire formed brass since i haven't shot this rifle before, and since this is a standard non...

I just threw in on the pre release/backorder for the whole kit and kaboodle. Hope I'm not waiting too long... Looks like my Giraud might go up for sale soon

A couple reloading questions for you all, i've got an SRS and HTI that i just picked up 338 and 375 Factory conversion kits for. .375CT What's your go to load for long range steel? Anyone tried the Lehigh 353gr copper solids? They look appealing on paper. Can't find much info on them in the...