Search results

I've searched to no avail, so I'm asking you all: The chamber on my DPMS SASS is 3.04" OAL to put the ogive on the lands, plus a few thousandths depending on how hard I'm pushing. I'm mag length limited to 2.845" (but probably won't exceed 2.840") and I'd like to seat Berger 168 Target VLDs...

I need to install a 2" section of picatinny rail on a round FF hand guard. Kits or a decent drill and install solution would be preferable. Solutions?

Hey all, I'm load developing for my .223. It's a heavy barrel Rem700. I was out last night with a buddy, and as I was shooting, the light was fading out. Long story short, 3 of 4 groups came in under an inch (3 shots each), but they were all triangles... shot about 9-oclock, shot about 1:30...

OK guys, here's one for ya: I've got a a DPMS 18" heavy barrel .308. I'm looking for a way to get the 208 AMAX, seated to mag depth (let's say about 2.820-ish) to give me about 2300-2400 fps out of the .308 case. The thought occurred to me that H110 is about my favorite powder in the .460 S&W...

Hey all- After exactly 37 rounds through my new DPMS LR-308 SASS, I'm noticing uneven (not sure if it should be called excessive or not) wear at the 12 o'clock position on the bolt at the locking lugs, when the BCG is removed from the weapon and the bolt is back in the BCG (as if in battery...

I will be paying off a DPMS SASS in the next few days. I'm pretty much going to start hand rolling for this gun from the get-go. I currently own a Forster NM Size/decap die for .308. Am I better off going with a Small-Base size die or will the NM FL die work ok? Thanks in advance!

Brownells sells an adapter for a flush cup to fit the original PRS buttstock. I ordered one, and it does not fit the PRS-2 (I actually mis-interpreted an outside link and thought it was for the 2 when I bought it, oops...) Basically the screws are farther apart on the PRS2 than the original...