• Cold Bore Ritual Contest - Only a Few Hours Left To Enter!

    What’s your cold bore ritual, that one thing you always do before your first shot to set yourself up for success? Winner gets new limited edition Hide merch. Remember, subscribers have a better chance of winning!

    Join contest Subscribe

Gunsmithing AICS / Duracoat

KeithR41

Sergeant
Minuteman
  • Jul 20, 2009
    1,277
    247
    51
    Oregon
    Has anybody applied Duracoat to an AICS stock. I sprayed a coat of tac. OD green, gave 24 hrs to dry and started masking (Also tried another coat with an approx. 3hr dry time, same problem.) I tried to move a mask and found the Duracoat was very easily peeling off. I was able to remove all of it with masking tape.

    This is probably the 15th gun I've done with Duracoat now and I've never had this problem. I wondering if there is a release agent in the stock.

    Anybody experienced this and how did you get around it.

    Thanks, Keith
     
    Re: AICS / Duracoat

    I have Duracoated every AICS skin I have ever owned and never had an issue. I always sand gently with some fine sandpaper or blast if you can. Use some good brake cleaner and you shouldn't have any issues. Did you mix the duracoat right?
     
    Re: AICS / Duracoat

    Yep, shake till rattle then more just cause. At first I thought maybe my mix was a little dry so I added a touch more hardner and a very small amount of reducer.

    I didn't sand before spraying just degreased with mineral spirits. The stock was brand new so it didn't have any grease other that finger print oils on it, unless like I said earlier, there was release agent or something from the factory on it.