Will the AICS mags reliably feed a 6mm dasher or the 6BR cases? I need some solid info on this subject before i go any further with my thoughts. Who can alter the mags to work if needed? I will be using a badger action, I hope!! Lee
Gunsmithing AICS mags and the 6BR or 6Dasher
- Thread starter skeetlee
- Start date
Re: AICS mags and the 6BR or 6Dasher
come on fellas i need some input here. Do you think a 6mm dasher would work in the aics magazine without any mods?? Please advise. Lee
come on fellas i need some input here. Do you think a 6mm dasher would work in the aics magazine without any mods?? Please advise. Lee
Re: AICS mags and the 6BR or 6Dasher
I have a Remington 700 chambered in 6 Dasher with the Badger M5 magazine kit and it works flawless. I do have a custom Kiff bolt which has the .062 firing pin and Sako extractor. I did slightly modify the ejector plunger, so it would sit slightly more forward to have better extractor pressure on the cartridge. I did not make any modifications to the mags, I load them with the cartridges to the ft of the mag. Hope this helps, Greg
I have a Remington 700 chambered in 6 Dasher with the Badger M5 magazine kit and it works flawless. I do have a custom Kiff bolt which has the .062 firing pin and Sako extractor. I did slightly modify the ejector plunger, so it would sit slightly more forward to have better extractor pressure on the cartridge. I did not make any modifications to the mags, I load them with the cartridges to the ft of the mag. Hope this helps, Greg
