So I put together a precision AR build recently, and while I'm getting some decent results during load development, I'm getting a fairly consistent flier that is dead north of the central group. At first I thought that it was a potential seating depth issue, and more prevalent on the first round chambered, but I believe I've had it show up on other shots as well. Have any of you experienced this, and if so, what was determined to be the culprit?
Full length sized LC 08 brass (I am not crimping, nor have these cases been annealed)
Wolf SR
Hornady 73 eld-m
BCM upper
LT Stealth 16"
JP Adj. gas
Fail Zero BCG
Seekins rail
Atlas bipod
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/pKbftcN.jpg"}[/IMG2]
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/YmXJtnf.jpg"}[/IMG2]
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/x6fI1c3.jpg"}[/IMG2]
Full length sized LC 08 brass (I am not crimping, nor have these cases been annealed)
Wolf SR
Hornady 73 eld-m
BCM upper
LT Stealth 16"
JP Adj. gas
Fail Zero BCG
Seekins rail
Atlas bipod
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/pKbftcN.jpg"}[/IMG2]
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/YmXJtnf.jpg"}[/IMG2]
[IMG2=JSON]{"data-align":"none","data-size":"full","src":"https:\/\/i.imgur.com\/x6fI1c3.jpg"}[/IMG2]
