I don't want to throw people under the bus, so lets say I have the following issue without naming names.
20MOA base of a reputable make. Slots measure .200 on the nose. I purchase a set of well known high quality rings. The lug that is supposed to fit the notch in the base measures .201-.202. Obviously, there is interference there.
My solution is to open up the rail by a couple thou', but I am curious as to where the problem lies. Rings or base?
20MOA base of a reputable make. Slots measure .200 on the nose. I purchase a set of well known high quality rings. The lug that is supposed to fit the notch in the base measures .201-.202. Obviously, there is interference there.
My solution is to open up the rail by a couple thou', but I am curious as to where the problem lies. Rings or base?