OK, I'm reaching out because I'm out of ideas.
When I neck size my Lapua 260 Rem brass with a redding nonbushing die after firing the cartridges they will chamber in the same rifle without a bullet seated...but, after I seat a bullet (Scenar 139g @ 2.80 col) it will not chamber far enough for the bolt to engage and close and a little force is needed on the bolt to extract the cartridge. IF, however, I full length resize the same brass and seat the same bullet the bolt will close.
What can I check or do differently.
Please stop the head banging from frustration...
Let me know if more info is needed.
Thanks!!!
When I neck size my Lapua 260 Rem brass with a redding nonbushing die after firing the cartridges they will chamber in the same rifle without a bullet seated...but, after I seat a bullet (Scenar 139g @ 2.80 col) it will not chamber far enough for the bolt to engage and close and a little force is needed on the bolt to extract the cartridge. IF, however, I full length resize the same brass and seat the same bullet the bolt will close.
What can I check or do differently.
Please stop the head banging from frustration...
Let me know if more info is needed.
Thanks!!!