I took out my new A.J Brown built R700 today for the 1st time with a freshly mounted PH 3-15x50 using 4/6 Seekin's rings.
I was trying to zero it in today hoping I could do it with less than 10 rds @ 100 yds. Well long story short, I fired 1 round just to see where I was at.
Windage was dead center and hit 6" low of center mark. So I fired 2 more rounds and the next hits were 4" up from that.
I tried to zero @ 2.5 mils and noticed that it climbed to the exact opposite side of the target 6" high, again windage was dead center. I fired another shot to check for consistancy and only this time it was about 6" completely off target high. I fired another shot again to check and it climbed only this time it nicked the very top of the target.
Maybe someone knows what I am doing wrong. I can't figure out what the issue is. I don't want zeroing to be to costly!
Thanks for any advice, I sincerely appreciate it.
Regards,
-Ms
I was trying to zero it in today hoping I could do it with less than 10 rds @ 100 yds. Well long story short, I fired 1 round just to see where I was at.
Windage was dead center and hit 6" low of center mark. So I fired 2 more rounds and the next hits were 4" up from that.
I tried to zero @ 2.5 mils and noticed that it climbed to the exact opposite side of the target 6" high, again windage was dead center. I fired another shot to check for consistancy and only this time it was about 6" completely off target high. I fired another shot again to check and it climbed only this time it nicked the very top of the target.
Maybe someone knows what I am doing wrong. I can't figure out what the issue is. I don't want zeroing to be to costly!
Thanks for any advice, I sincerely appreciate it.
Regards,
-Ms