Rifle Scopes GDI prom mount on a bolt action

DrewC

Private
Full Member
Minuteman
May 19, 2014
104
27
Washington
I won’t be home for a bit so I can’t check for myself so I figured I’d ask here. I have new bolt action that I’m going to use a GDI prom mount on it and was just wondering if it would provide enough eye relief without running out of back rail. I rarely see these mounts on a bolt action so searching around online isnt helping.
 

DrewC

Private
Full Member
Minuteman
May 19, 2014
104
27
Washington
I have it sitting just sitting in my safe. the rifle is a Cadex so i was hoping it would work.
 

LawnMM

Harbinger of Sarcasm
Full Member
Minuteman
  • Jul 5, 2009
    5,205
    8,433
    Colorado
    Not because it won't provide enough eye relief, because to get it to hold zero you have to tighten the clamp down to the point where you need tools to install/remove it.

    Could probably sell it to somebody on Arfcom, get enough from the sale to buy a SPUHR
     

    DrewC

    Private
    Full Member
    Minuteman
    May 19, 2014
    104
    27
    Washington
    I have a few on my gas guns and never had any issues with them, I had this mount forever and was hoping to put it to use. Just never tried them on a bolt.
     

    LawnMM

    Harbinger of Sarcasm
    Full Member
    Minuteman
  • Jul 5, 2009
    5,205
    8,433
    Colorado
    I had one for a bit, eye relief wasn't an issue, it does sit a bit higher though but if you have an adjustable cheek it shouldn't be an issue

    What gas guns were you using them on?