So I got the bright idea to install my new trigger myself. Bad idea. The Timney instructions say not to drive the pins out so far that the bolt stop and bolt stop spring don't fall out. Well my last little "tap" wasn't so little and I drove the pin all the way out and the bolt stop and spring fell out. I thought I put them back in the correct way but now when you insert the bolt the bolt stop doesn't stay up and hold the bolt in the action. Can anyone tell me what I did wrong? It seemed to dry fire ok other then the bolt coming all the way out when I cycled it the first time and me going wtf? lol. Also when I took factory trigger out a little arm and spring fell out as well and I don't know if I needed to keep those in there or if they were just part of the factory trigger. The Timney instructions didn't show them or mention them.