| I am trying to do something with my PAS23 thermal scope to make it weapon mounted. It does not have internal reticle adjustments so i made up this Picatinnty mount for an Elcan mount.|
I am thinking about putting a NVM bracket on the PAS23 and using one of the available NVM rail brackets to mount on the Elcan assembly.
I need this part that Insight WTM uses this NVM type dovetail as well as many ATN products.
This is what I have so far.
Yep, that is clearly stated in linked thread from Arfcom, I should have noted that.Don’t weapon mount the MTM. There is a specific model (the WTM) for weapon applications. At a minimum the system may shut off during weapon shock. At worst you could burn rows in the FPS.
Normally I would disagree with you but upon further thought I realized that the PAS23 is different in one respect from many thermal scopes.Yep, that is clearly stated in linked thread from Arfcom, I should have noted that.
Note: I have zee-ro experience with this matter I was just bored and did some google research on the mount for you. Lol
Look for part number MTM-022 for the bayonet style mount or MTM-027-A1 for a BNVS (PVS-15) style mount.I am trying to helmet mount mine if anyone knows how to make a mount or where to buy let me know.
I've tried looking up both the Mtm-022 is discontinued and I cannot find anythingLook for part number MTM-022 for the bayonet style mount or MTM-027-A1 for a BNVS (PVS-15) style mount.
Give EOTECH a call, they used to rep Insight gear to the general public.
Cant post the pics right now, but.I am trying to helmet mount mine if anyone knows how to make a mount or where to buy let me know.
Awesome man I appreciate it could you just text them to my cellCant post the pics right now, but.
I took a pvs14 j-arm. Measured the pas23 helmet mount I have for one unit. Then cut the j-arm end off, drilled a 1/4" hole at the same distance as the pas23 mount, then dremel cut a inlet/slot for the 23 raised hump to fit in. Used the j-arm screw. And it works fine. When I get back home next day or two, will post pics. Cutting the slot with a dremel was a pita.... an end mill would have done it in 5 minutes or less... but...
It will only work on one side like the original pas23 mount. Wont flip eyes like it does on pvs14.
Easier than finding a pas23 mount on Ebay and paying 150.00 and up for it. Saw one for 200.00 about 8 months back. Saw a pas23 dovetail mount go for 380.00 on ebay.
My $14.00 used j-arm and three hours work, works just fine...
Pics will follow.
Posted them on hide once b4 pte-scout. Cant find the post now. Old pics lost on old dead phone.