This is probably a question with a fairly narrow scope but I wanted to see what you guys with honed Forster FL sizing dies are having them honed to for your 6.5 CM?
Ideally I would like to be able to order a honed die/dies right off the bat rather than receiving it, measuring loaded cases, then sending it back to have it honed. I understand that for each brand of brass the measurement will be a little different as well as everyone may be loading to different neck tensions which is why I'm hoping to get a decent sample size with this thread.
I will primarily be looking to load Lapua SRP brass shooting for the go to neck tension of .002 but it would be nice to also get the dimensions for anyone using say Alpha Brass or even Peterson Brass just in case I need some options down the road.
I thought about just calling Forster to pick their brain but I figured I'd start here first and see what you guys have to say. This will be first step into the world of sizing for specific neck dimensions aiming for precise neck tensions as I've previously only used the a basic RCBS FL sizer die with expander ball so please forgive any ignorance shown in my thought process on this.
Thanks in advance!
Ideally I would like to be able to order a honed die/dies right off the bat rather than receiving it, measuring loaded cases, then sending it back to have it honed. I understand that for each brand of brass the measurement will be a little different as well as everyone may be loading to different neck tensions which is why I'm hoping to get a decent sample size with this thread.
I will primarily be looking to load Lapua SRP brass shooting for the go to neck tension of .002 but it would be nice to also get the dimensions for anyone using say Alpha Brass or even Peterson Brass just in case I need some options down the road.
I thought about just calling Forster to pick their brain but I figured I'd start here first and see what you guys have to say. This will be first step into the world of sizing for specific neck dimensions aiming for precise neck tensions as I've previously only used the a basic RCBS FL sizer die with expander ball so please forgive any ignorance shown in my thought process on this.
Thanks in advance!