I just got around to installing my conversion today, got my press apart then realized I was missing the 'spent primer tube tool.' Is it threaded? Is it something I could use a bolt in place of?
Hornady LNL EZ-ject conversion
- Thread starter michaeltx
- Start date
-
- Tags
- conversion ezject hornady lnl
Re: Hornady LNL EZ-ject conversion
Nevermind, went brute force. I took a pair of vice grips, mashed the hell out of the end of the tube and just cut it off. Seems to eject much better now. I need to load a few hundred 45 auto later, I'll guess I'll see.
Nevermind, went brute force. I took a pair of vice grips, mashed the hell out of the end of the tube and just cut it off. Seems to eject much better now. I need to load a few hundred 45 auto later, I'll guess I'll see.
Re: Hornady LNL EZ-ject conversion
How did you get the hex head screws that hold the base plate to the ram out? I have broken three wrenches and haven't budged them a bit. I have also twisted two wrenches 360 degrees but still no luck. Any ideas?
How did you get the hex head screws that hold the base plate to the ram out? I have broken three wrenches and haven't budged them a bit. I have also twisted two wrenches 360 degrees but still no luck. Any ideas?
Re: Hornady LNL EZ-ject conversion
Mine came loose with a 3 inch long allen wrench, but it was a lot of torque for that tool. Any tighter and I was going after a t-handle. Nothing weird, just a little tight.
Mine came loose with a 3 inch long allen wrench, but it was a lot of torque for that tool. Any tighter and I was going after a t-handle. Nothing weird, just a little tight.
Re: Hornady LNL EZ-ject conversion
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Pat Dufrene</div><div class="ubbcode-body">How did you get the hex head screws that hold the base plate to the ram out? I have broken three wrenches and haven't budged them a bit. I have also twisted two wrenches 360 degrees but still no luck. Any ideas? </div></div>
Use a little heat.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Pat Dufrene</div><div class="ubbcode-body">How did you get the hex head screws that hold the base plate to the ram out? I have broken three wrenches and haven't budged them a bit. I have also twisted two wrenches 360 degrees but still no luck. Any ideas? </div></div>
Use a little heat.
Re: Hornady LNL EZ-ject conversion
While OT...check out these "add-ons".... http://ultimatereloader.com/?p=340 and... http://ultimatereloader.com/?p=404
Just an FYI.
While OT...check out these "add-ons".... http://ultimatereloader.com/?p=340 and... http://ultimatereloader.com/?p=404
Just an FYI.
Similar threads
