Does anyone know if there is a coating... or covering that can be applied to the inside of a Kydex holster so that it does not scratch or put rub marks on a slide?
Thanks
Matt (LEO SOUTH GA.)
Thanks
Matt (LEO SOUTH GA.)
It isn't kydex that wrecks gun finishes, it is the dirt between the kydex and the pistol. A simple way to figure this is that plastic is softer than steel, so the plastic can't abrade the harder steel. However, if you get grit between the kydex and your pistol, the grit WILL act just like sand and abrade your pistol.
I have used kydex holsters and leather holsters for many years. Keep your kydex clean, and you won't have a problem.
Not true. It depends on the finish. I have used all type of holsters and the only ones that haven't worn on my pistols finishes are my Garrett Industries and Remora holsters. My Comp-tac Spartan was horrible on both parkerized finishes and did leave noticable scratches on my glocks finish (even after multiple cleanings with alcohol). My Bravo concealment holster was much better and left minimal wear as did my Blackhawks, Bianchi, and Raven Concealments. The Garret Holsters are a kydex shell with leather lining and Remoras are a rubberized outer shell with a nylon lining. These days Garrett is wher my business goes. Great products, great service, and great people.
Waxing might to be remove any unwanted hair from inside the holster...(joking, but waxing jokes are all over TV now..)