Magnetospeed on Omega w-brake

[Chad493]

Hi everyone,

I'm planning on getting a Chrono in the near future and was looking at the magnetospeed units. I have a silencerco Omega 300 with the anchor brake. Would I have to get the flat front cap to be able to use them together?

 

[JMGlasgow]

Nope, I run a Magnetospeed on my Harvester with the same brake.

 

[Chad493]

Thanks

 

[newgunguy3]

I use the Omega with the brake exclusively. When I test a new load I don't take the brake off and the MS runs just fine.

 

[tomcatfan]

I use the Omega with the brake exclusively. When I test a new load I don't take the brake off and the MS runs just fine.

Same here. I use my magnetospeed on my Omega and anchor brake with no problem.

 

[Nate4641]

I use a V3 on my Hybrid with a .30cal anchor brake. I would recommend playing with the mounting plates before you go to the range to figure out which ones to use for each setup you plan to mount the chrono to. I numbered the hard plastic mounts 1-3 and the rubber L and S, then played around with my different suppressors and rifles and wrote down which combos to use for each setup. I also marked the strap with a white out pen for where the rubber strap insulator piece goes. Saves time at the range when you know what attachments you need.