Need a gunsmith to inlet a DBM and thread a barrel - SE TN or North GA.

[CharlieTN]

Hello all,

I have a Rem 700 that I need to have inletted for the PTG bottom metal as well as have the barrel threaded for a PWS PRC brake.

The rifle is in a B&C M40 Medalist.

Any suggestions on a gunsmith either in the North Georgia or SE Tennessee area that could do it or someone I can send it to?

Thanks,

Charlie

 

[ColbyLang]

APA is in Jefferson GA. Not sure what kind of wait time you can expect though. Jered and his boys in the shop sure are busy.

 

[I Am Hero]

Loads of places you can send it to. I had CDI do the inletting for my bottom metal when I bought it from them because they had a special that they would do it for free. Anyways they have awesome products, awesome services, and great customer service. They are just south of you in Florida.

 

[bryanZ06]

Check with Accurate Ordnance. They did some work for me recently and not only was the turnaround was fast, but the work was really nice too.

 

[Brux]

AO

 

[CharlieTN]

Thanks for the leads. I have e-mails in to both. Time line is not too bad, just need it back by mid October for hunting season.

Thanks.