Need advice

[MeanJeane]

Im new to reloading. I am on my 4th time reloading a lot winchester 300wm brass. After recently reloading them for the 3rd time I prepped again to reload and every single peice of brass will not hold a bullet. The bullet will fall right in. The load is 73 grains of h1000 and 208 amax. What does this mean. Ive searched and didnt quite find an answer to my question. I can with no resistance push and pull a bullet in and out of each peice of brass.

 

[Rob01]

Re: Need advice

Sure your die was turned down enough. Sounds like it didn't get enough neck tension. Also are you using the expander?

 

[MeanJeane]

Re: Need advice

I cant even seat them if the bullet falls down into the brass?

 

[MeanJeane]

Re: Need advice

I am using an rcbs FL sizing die

 

[MALLARD]

Re: Need advice

remove your expander/decapping assembly from your die and try again , tell us if it worked.

 

[MeanJeane]

Re: Need advice

It worked. Thanks!

 

[Rob01]

Re: Need advice

I meant turned the die all the way down to the shell holder. Not the seater.

That's why I asked about the expander as well.

 

[MeanJeane]

Re: Need advice

Gotcha