I received my new GAP Crusader last week but had to wait on UPS to deliver the scope and reloading equipment (new dies, brass, bullets, etc). I was able to spend a couple of hours today at the range and feel that I accomplished a lot. I am following the GAP break-in procedure to the T. I only had time for three shots today. I plan to finish the break-in tomorrow. I was very surprised by how little the copper fouling was. It took no more than two passes with the copper solvent to get a clean patch. However, I was able to get the gun on paper on my second shot. The third shot was 2 moa left and 1 moa high. The scope is a NIGHTFORCE NXS 12-42 X 56mm with 1/8 moa adjustments and the NP-R2 recticles. I already like this gun!
