Re: Nordic Components NC22 Dedicated Upper Receiver
Yes mine is a 16 inch gun with a full length tube and a full rail.
The rail and the full length tube are add on's to the system.
As for accuracy I zeroed iron sights at 25 yards with it. I shot at 3 inch grey circles. It was a bit hard to see while zeroing. I was just using a front rest with no rear bag and I was coming below the circle and back up just trying to get the gun to shoot within a 3 inch cirle. I was getting roughly 3 1/2 inch groups with iron sights on average.
I then took the iron sights off to zero the red dot and at 25 yards I was able to keep it under 2 inches per group.
I then put up a 6 inch bullseye and started fring 2 shot pairs standing at 25 yards shooting them as fast as possible. I did this 15 times for 30 total rounds and all 30 rounds were in the 6 inch bullseye.
I then went to 50 yards and shot 6 inch plate racks. I was able to hit 6 inch plates all day ith this rifle setup.
Plain and simple i am not trying to shoot sub 1 inch groups with this rifle. Its simply a Blaster
that is going to allow me to run and gun and practice for 3 gun competetion at a fraction of the price of waisting .223.
I have had mine 4 days and I have fired over 2500 rounds thru it and I have had not one malfunction or failure to feed with it. I even fired a 30 round magazine as fast as i could thinking this thing will jam and no luck it just wanted more ammo.
If you are looking for a fun toy that runs this is it. If we get enough interest I am sure I can get a group buy for uppers if you guys want.
Just post the interest here.