Hello everyone!
Ann currently using a pair of Tac A1s, one in .223 and the other in 6.5CM, both with Minox 5-25 ZPTACs and suppressors (UK).
I use 69 SMK (UK HPS) and 140 BTHP (Hornady American Gunner) factory loads for general shooting.
I want to retain the brass for reloading.
I am currently wanting to set my FL dies up to provide 0.002 bump, however, I notified that the Hornady brass gave a fairly wide variety of measurements when using a Hornady comparator tool.
As a result - I’m unsure how to set up my die, do) group brass into the various lengths and adjust the dies to provide 0.002 bump to each group or b) do I expect a certain amount of growth from the shorter cases and set up the die to address the longer cases?
Many thanks in advance!
Ann currently using a pair of Tac A1s, one in .223 and the other in 6.5CM, both with Minox 5-25 ZPTACs and suppressors (UK).
I use 69 SMK (UK HPS) and 140 BTHP (Hornady American Gunner) factory loads for general shooting.
I want to retain the brass for reloading.
I am currently wanting to set my FL dies up to provide 0.002 bump, however, I notified that the Hornady brass gave a fairly wide variety of measurements when using a Hornady comparator tool.
As a result - I’m unsure how to set up my die, do) group brass into the various lengths and adjust the dies to provide 0.002 bump to each group or b) do I expect a certain amount of growth from the shorter cases and set up the die to address the longer cases?
Many thanks in advance!