Rem 700 5R extraction issue

[Sgt_Jamez]

I've read about people having extraction issues. Mine is the type where it either pulls the case out but leaves it on the mag or won't pull it out at all on the first try (but will if tried again). The bolt doesn't have any trouble closing. Is this something that would be solved by replacing the extractor? I did scrub the chamber out really well the last time I cleaned it, but haven't fired it since the cleaning. I looked at the extractor, but can't see anything definitively worn. Can anyone chime in with advice? Thanks.

ps My rifle is a 308 if it matters

 

[Sgt_Jamez]

Really? No one?

 

[RTK]

Is it a pinned/peened extractor or not. If "not" pinned/peened you can remove it and snap a new one in for a few buck, if pinned/peened you will need to by a little tool, not expensive.
I have had good luck kinda re-working (bending) a pinned extractor with an awl or dental pick type of tool.
Also try looking at the ejector making sure it isn't sticking

 

[FALex]

replace the extractor spring, should be good to go.

 

[Sgt_Jamez]

As far as I can tell it's just the clipped in one. How can I tell? The ejector plunger seems smooth.

 

[RTK]

You will see a pin that has been peened on the outside can't miss it

 

[Sgt_Jamez]

Ok in that case it's not a pinned one. I have a new extractor on the way!